Parkside PISG 80 A2, Assembly, Operating And Safety Instructions, Translation Of The Original Instructions

Page: 29 / 83

29 GB/IE
- Open windows or vent to ensure
air supply.
- Wear safety goggles and a
mask.
Wear gauntlet gloves made
from suitable material (leather)
on both hands. These must be in
good condition.
Wear suitable aprons to protect
the clothing from sparks and
burns. When required based on
the working method, e.g. welding
overhead, wear a protective suit
and, if necessary, a head guard.
Protecting against
rays and burns
Mark the work area with a
sign „Danger! Do not look into
flames!“ to indicate the risk to
the eyes. If possible, shield the
work areas to protect persons
nearby. Keep unauthorised per-
sons away from the welding area.
Walls in the direct vicinity of fixed
work areas should be neither
light coloured nor glossy.
Protect windows against rays
passing through or reflecting at
a minimum to head height, e.g.
with suitable paint.
Installing the welding shield
Install the handle
8
on the welding shield
7
as shown in Fig. C.
Install the protective glass
11
on the welding
shield
7
as shown in Fig. C.
Then fold the three sides of the welding shield.
The two sides each connect to the top with two
press studs.
Start-up
Note: The welding tool is suitable for welding with
electrodes.
Use electrode retaining clips without protruding
retaining screws meeting today‘s safety stand-
ards.
Be sure the ON / OFF switch
9
is set to posi-
tion “O“ (“OFF“) or the main supply cable is
not plugged into the mains socket.
Connect the welding cables according to po-
larity and electrode manufacturer instructions.
Put on suitable protective clothing according to
provisions and prepare the work area.
Connect the earth terminal to the workpiece.
Secure the electrode in the electrode holder
5
.
Switch on the device by setting the ON / OFF
switch
9
to the “I“ (“ON“) position.
Set the welding current with the control knob
3
according to the electrode used.
Safety instructions / Installing the welding shield / Start-up
281479_Inverter Schweissgeraet PISG 80 A1_content_OS.indd 29 28.12.16 12:19
Note:
Please see the table below for the weld-
ing current according to electrode diameter.
Attention:
When welding with electrodes
(MMA - manual metal arc welding),
terminal must be connected to positive (+)
or negative (-) according to the welding rod
4
Note:
Do not bring the earth terminal
and the electrode holder /electrodes into
direct contact with one another�
5
4
the electrode holder and the earth
5
rod specifications.
44
4