Parkside PISG 100 A1, Operation And Safety Notes Translation Of The Original Instructions

Page: 15 / 61

GB/IE/NI 15
–
if possible, devices and systems at risk from interference radiation
should be removed from the work area or shielded.
Note!
This device complies with IEC 61000-3-12, provided that the Ssc
short circuit power is larger or equal to 3553.5 kW at the interface
point between the operator’s supply and the public supply. It is the
responsibility of the installer or user of the device, after consultation
with the distribution system operator if necessary, to make sure that
the device is only connected to a supply with an Ssc short circuit
power which is larger or equal to 3553.5 W.
Note!
The device is only for use in areas which are supplied with a current
load capacity of at least 100 A per phase.

Before using the device

Take the device and accessories out of the packaging and check them for damage
(e.g. transport damage).

Fix the carrying strap
1
onto the device (see Fig. C1 – C4).

Fit welding mask

Fit the handle
8
onto the welding mask
7
, as shown in Fig. A.

Fit the protective glass
11
onto the welding mask
7
, as shown in Fig. B.

The protective glass
11
must be pushed in from the top.
NOTE: If you are not able to push the protective glass
11
in fully, gently press on the outside of the
protective glass
11
.

Using the device
NOTE: The welder is designed for welding with electrodes.

Use the electrode holder clamps without protruding bracket screws, which meet the current safety
standards.

Make sure that the ON/OFF switch
9
is set to position “O” (“OFF”) or that the power cable
10
is
not plugged into the socket.

Put on appropriate protective clothing in accordance with the specifi cations and prepare your work
station.

Connect the earth terminal
4
to the workpiece.

Clamp the electrode into the electrode holder
5
.

Connect the mains cable
10
to the socket.

Switch the device on by setting the ON/OFF switch
9
to the “I” (“ON”) position.

Adjust the welding current using the rotary knob
3
depending on the electrode being used.
385180_2107_Inverter_Schweissgeraet_PISG_100_A1_content_LB6_GB.indb 15 385180_2107_Inverter_Schweissgeraet_PISG_100_A1_content_LB6_GB.indb 15 16.12.21 11:30 16.12.21 11:30