Parkside PHKS 1350 A1, Original Operation Manual

Page: 11 / 28

8 PHKS 1350 A1
GB
IE
Initial operation
Fitting/changing the saw blade
Always pull out the plug from the mains before
changing the saw blade !
1. Set the cutting depth (using the locking screw )
to the minimum position, 0 mm.
2. Swing the blade guard back using the release
lever and put the device down.
3. Press the spindle lock button (until it engages)
and use the Allen key to release the clamping
screw/washer . Now remover the clamping
screw/washer and the clamping fl ange
(see also Fig. A).
Fig. A: Changing the saw blade
4. Remove saw blade.
5. Fitting a saw blade is carried out in the
reverse order.
6. Press the spindle lock button (until it engages)
and use the Allen key to tighten the clamping
screw/washer .
WARNING!
► The arrow on the saw blade must corre-
spond to the arrow showing the direction of
rotation (running direction shown on the
device).
■ Ensure that the saw blade is suitable for the
rotational speed of the tool.
Mounting/setting the guide fence
♦ Loosen the wing screw and insert the guide
fence into the guide fence slot .
♦ Set the desired cut width with the help of the
scale on the guide fence and the marking
arrow in the base plate (see also Fig. B).
0 45 45
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw .
Connecting the sawdust extraction
appliance
♦ Attach the adapter for dust extraction to the
chip ejector .
♦ Connect an approved dust and chip extraction
device.
Operation
Switching on and off
Switching on:
♦ Push the safety lock-out to the left or right
and keep it pressed.
♦ Press the ON/OFF switch . Once the saw is
running you can release the safety lock-out .
Switching off :
♦ Release the ON/OFF switch .
Setting the cutting angle
You can select the cutting angle with the help of the
cutting angle scale .
■ Release the wing screw on the cutting angle
preselector , set the desired angle on the
cutting angle scale and then re-tighten the
wing screw.
IB_108024_PHKS1350A1_LB6.indb 8 23.01.15 11:06