9
GB
Initial use / Troubleshooting / Maintenance, cleaning and storage / Service
Switching off the device
Set the temperature control
3
back to
MIN
.
To prevent heat from building up inside the unit,
allow the fan to continue running approx. 2 min
more before setting the heat switch
2
to the
0
position.
To actually switch the device off, unplug the
mains plug to disconnect the heater fan from
the mains.
Overheat protection
This appliance is fitted with overheating protection.
If the device overheats, the heating element will au-
tomatically switch off. However, the fan will continue
to run to ensure fast cooling. The device will automat-
ically restart once it has cooled down accordingly.
ATTENTION! There typically is a reason
for overheating! It can indicate a fire
hazard!
Check if the device is able to emit heat adequate-
ly: is the device covered or too close to a wall
or another obstacle? Are the front and rear
grates clear? Has the fan jammed?
If possible, correct the problem or contact the
Service hotline (see chapter Service).
Even if you are unable to determine the cause
and the overheat protection is tripped again,
you will need to switch the device off and con-
tact the Service hotline (see chapter “Service”).
Troubleshooting
Error
Possible cause Solution
The device
won't
switch on.
The mains plug
is not connected
to a socket.
Insert the mains
plug into the
mains socket.
The socket is not
supplying elec-
tricity.
Check the fuses
in the house.
Error
Possible cause Solution
The device
is not emit-
ting heat.
The heat switch
2
is not on.
Set the heat
switch
2
to the
desired setting.
The temperature
control
3
is set
to MIN.
Set the temper-
ature control
3
to MAX.
Heating element
defective.
Contact custom-
er service.
Maintenance, cleaning
and storage
Always disconnect the mains plug when the
device is not in use and before cleaning or in
the event of malfunctions!
Only clean the device when switched off and
cold.
Ensure no moisture enters the device during
cleaning to prevent damaging the device be-
yond repair.
Only clean the housing with a slightly damp
cloth and mild washing-up liquid.
Use a vacuum cleaner to remove any dust on
the grate.
Store the device in a dry location.
Service
Should problems arise whilst operating your ROWI
Electronics product, please proceed as follows:
1. Contact us
You may contact the ROWI Electronics Service
Team at:
ROWI Electronics GmbH
Augartenstr. 3
76698 Ubstadt-Weiher, Germany
[email protected]
Service hotline: +49 (0) 7253 9460-40
Safety / Before Initial Use / Initial use
