Parkside PFSM 500 A1, Translation Of The Original Instructions

Page: 11 / 52

11
GB
• The device is intended to be used with
water.
Checking the closure
1. Unfold the work surface (4).
2. Check that the closure (24) is firmly
fixed in the drain hole (25).
Fill water into the tank of the device. The
filling level is marked on the protective co-
ver of the cutting disc.
Operation
Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Only use grinding discs and
accessories recommended by the
manufacturer. Using other attach-
ment tools and other accessories
can represent a risk of injury for
you.
- Never operate the device wit-
hout protective equipment.
Keep your hands away from
the grinding disc when the
device is in operation. Injury
hazard!
Never operate the device
without water.
The workpiece must not be
too small. Otherwise, your
fingers and hands will be
placed in extreme danger
due to the close proximity of
the cutting disc. The work-
piece must not be too large
either. It must be ensured
that it is securely supported
on the work surface.
Switching on and off
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
1. To switch on, press the “ I ” On switch
and the device starts up ( 5).
2. To switch off, press the “ 0 ” off switch
and the device switches off ( 6).
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disc will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disc, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disc runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Performing a parallel cut
1. Adjust the parallel stop (9) to the desi-
red distance from the full-rim diamond
cutting disc (15).
2. The desired width can be read off on
the measuring scale (8).
3. Fix the parallel stop (9) firmly in place
with the two star grips.
4. Place the workpiece on the work sur-