14
GB/IE/NI
ductive walls (boilers, pipes,
etc.), in wet rooms (sweating
through work clothes),
the output voltages of the
welding device in no-load
operation must not be higher
than 48 Volts (effective value).
Based on the output voltage
this welding device may be
used in these conditions.
z
Protective clothing
Whilst working, the welder
must protect all body parts
from radiation and against
burns by means of appropriate
clothing and face protection.
Remember the following steps:
– Put on protective clothing
before welding.
– Wear gloves.
– Open windows to ensure
air supply.
– Wear protective goggles.
Wear gauntlet gloves made of
suitable material (leather) on
both hands. These must be in
good condition.
Wear suitable aprons to
protect clothing from sparks
and burns. If work such as
overhead welding is required,
wear a protective suit and,
if necessary, a head guard.
z
Protection against
radiation and burns
Warn of the danger to the
eyes by hanging up a sign
saying “Caution! Do not look
into flames!“. If possible,
shield the work areas to
protect persons in the vicinity.
Keep unauthorised persons
away from the welding area.
Walls in the direct vicinity
of fixed work areas should
be neither light coloured nor
glossy. Windows should be
blocked off to at least head
height to prevent the escape or
reflection of radiation, e.g. by
painting with a suitable paint.
z
EMC device classification
As per the standard
IEC 60974-10, this welding
device is a welding unit
with class A electromagnetic
compatibility. Thus it complies
with the corresponding require-
ments for industrial and domes-
tic use. In residential areas, it
can be connected to the public
low-voltage supply systems.
Even if the flux cored wire weld-
er complies with the emission
limit values of the standard, arc
Safety instructions
