Parkside PFBS 160 B2, Instruction Manual, Page: 16 / 94

PFBS 160 B2 GB
│
CY
│
13 ■
■ Note that the maximum diameter of the grind-
ing assembly and of grinding cones, pencil
grinders and grinding points with a thread insert
may not exceed 55 mm and the maximum
diameter for sandpaper sanding accessories
may not exceed 80 mm.
NOTE
► The max. permissible length of a mandrel is
33 mm.
■ Store the accessories in the original box or store
the accessory components somewhere else to
protect them from damage.
■ Store the accessories somewhere dry and not in
the vicinity of aggressive media.
■ If you exert too much pressure, the fitted tool
can break and/or the workpiece could be dam-
aged. You will achieve optimum working results
by moving the tool over the workpiece at a
steady speed and while exerting light pressure.
■ When carrying out cutting work, hold the appli-
ance firmly with both hands.
■ Observe the data and the information in the ta-
ble to prevent the end of the spindle from touch-
ing the perforated base of the grinding tool.
Flexible shaft
■ Never operate the spindle lock while the motor
is running. Otherwise, the appliance or the flex-
ible shaft may be damaged.
♦ Screw the union nut anticlockwise off the
appliance and store it carefully.
♦ Press the spindle lock and hold it down.
♦ Screw the tensioning nut anticlockwise off
the appliance.
♦ Fit the flexible shaft onto the appliance. To
do this, the internal access of the flexible shaft
push the tensioning nut into the collet chuck
, .
♦ First tighten the tensioning nut and then the
union nut
14b
of the flexible shaft clockwise
onto the appliance with the combination span-
ner .
♦ Place the desired accessory into the collet
chuck , of the flexible shaft.
♦ Push the black the collar back onto the flexible
shaft to lock the spindle.
♦ Open the collet chuck mount on the flexible
shaft with the combination spanner . Fit the
attachment and screw the collet chuck mount
back in place.
Stand for the multi-tool
♦ Screw the stand into the clamping device .
NOTE
► Depending on the desired attachment onto a
vertical or horizontal surface, you can screw
the stand into the clamping device in two
different positions.
♦ Screw the clamping device onto the edge of
a work bench or table with a maximum thick-
ness of 55 mm.
♦ The stand is height-adjustable. Undo the
upper part of the stand by turning it anti-
clockwise (−). Pull out the tube to the maximum
height and lock it again by turning it clockwise
(+).
♦ The mount is also height-adjustable; turn
the black thread anticlockwise. After you have
set the mount to the correct height, tighten the
thread by turning in the opposite direction.
♦ Fix the appliance with the metal clip onto the
mount of the stand . The mount can be
turned 360°.