Parkside PEH 30 C3, Translation Of The Original Instructions

Page: 11 / 43

PEH 30 C3
GB
│
IE
│
NI
│
CY
│ 7 ■
Operation
Switching on and off
Switching on
♦ First, press the safety lock-out .
♦ Then press and hold the ON/OFF switch .
You can now release the safety lock-out .
Switching off
♦ Release the ON/OFF switch .
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked .
Setting the cut depth
Use the dial to adjust the cutting depth
(0–3 mm) in 1/10 mm increments using the
cutting depth scale .
Dust/chip extraction (see fig . A)
WARNING!
Always wear a dust mask!
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance .
Adjustable chip ejector (left/right)
♦ Unlock the chip ejector by turning it in the
opposite direction to the arrow (from the
“LOCK” position) .
♦ Pull the chip ejector out of the appliance .
♦ The chip ejector can be attached to the
plane on the left or the right . Make sure that
the tab on the chip ejector fits into the corre-
sponding recess on the housing .
♦ Push the chip ejector into the appliance .
♦ Lock the chip ejector by turning it to the
position “LOCK” .
External extraction
When using dust extraction systems, e .g . a work-
shop extractor, it may be necessary to use the
adapter for external extraction . The vacuum
cleaner must be suitable for the material being
processed .
Connecting
♦ Push the adapter for external extraction
firmly into the chip ejector .
♦ Push the hose of a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the chip ejector (or the adapter for
external extraction , if required) .
Removal
♦ Pull the hose of the vacuum cleaner off the chip
ejector or the adapter .
♦ Pull the adapter for external extraction off .
Parking shoe (see fig . B)
The parking shoe allows you to put down the
appliance without risking damage to the work-
piece . While working, the parking shoe is
flipped up and rear part of the plane sole is
exposed .
Planing
CAUTION! RISK OF KICKBACK!
► Always switch the appliance on before
applying it to the workpiece .
♦ Set desired cut depth .
♦ Switch the appliance on .
♦ Place the appliance with the front part of the
plane sole on the workpiece .
♦ Move the appliance with straight, even motions
over the workpiece .
♦ Push forward slowly and do not exert excessive
pressure on the plane sole . Excessive speed
reduces the surface finish and can lead to a jam
in the chip ejector .