Parkside PDWE 8 A2, Instructions Manual

Page: 9 / 81

9 GB/CY
Safety notes for using pneumatic devices / Installation
away from the maintenance
unit and the connected com-
pressed air tools.
„
Only use genuine spare parts
for repairs. Any non-genuine
spare parts may cause severe
damage.
„
When conducting any main-
tenance, setting and repair
work, always disconnect the
maintenance unit from the
compressed air supply first.
„
Changes to the maintenance
unit are forbidden.
„
Use the maintenance unit only
when it is in an impeccable
condition. In doubt, use a spe-
cialist's advice.
„
Have repairs only conducted
by qualified specialists.
User safety
Try out the pneumatic tool
used before every use.
Never use the compressed air
maintenance unit with any higher
operating pressure then indicated
in the technical data. Before you
connect your pneumatic tools to
the pneumatic maintenance unit,
ensure that they are properly and
securely connected.
Forbidden uses
Do not use this mainte-
nance unit in a potentially
explosive environment. Avoid
working in environments with sub-
stances such as flammable gas-
es, liquids, paint and dust mist.
These substances may inflame
due to very hot surfaces at the
pneumatic unit.
Important note:
Do not use the mainte-
nance unit in connection
with pneumatic devices that
must not use any prepared com-
pressed air (e.g. grease guns,
sand-blasting units, tyre fillers,
etc.).
z
Installation
Attention:
To minimise potential injury or dam-
age, the maintenance unit must be
installed on a suitable wall before first com-
missioning. Ensure a stable and horizontal
assembly of the pneumatic maintenance unit.
„
Use the attachment unit
5
to mark the
wall for wall installation and for screwing
on with matching connection material
(see Fig. D).
5
D