12 GB
Commissioning
Connecting
Note:
only use connection hoses with a minimum
inside diameter of 9 mm.
First wrap a piece of Teflon tape (not included)
around the outer threads of the plug nipple
9
and the lubricator
11
(see fig. B).
Now screw the plug nipple
9
into the thread
of the lubricator
11
(see Figure C).
You must use an open-end spanner to tighten
this connection with moderate force.
Now turn the combination of lubricator
11
and
plug nipple
9
into the connection thread
2
of the impact driver (see Fig. C).
Also retighten this connection with an open-end
spanner.
Now press the air hose onto the plug nipple
9
using a little force, until the hose locks in.
ATTENTION!
Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two screw
connections between lubricator
11
, coupling
and machine are securely seated.
Adjusting the compressed air
Note:
this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.
Only use filtered, lubricated and regulated
compressed air.
Adjusting the torque
Set the torque control
3
to the correct torque
by pressing it toward the housing and turning it
until it locks at the desired setting.
Be sure the operating pressure of the compres-
sor is between 5 and 6.3 bar.
Note:
the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.
Setting
1
(low, min.)
2
(normal)
3
(high)
4
(extra high,
max.)
Initial use
Activate the trigger
4
to start the equipment.
Release the trigger
4
to deactivate the equip-
ment.
Changing rotation
ATTENTION!
The device must come to a
complete standstill before changing the direc-
tion of rotation.
ATTENTION!
A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note:
The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch
6
to change the direction of the impact driver.
Push the bolt forward in the direction of the „F“
marking („Forward / Fasten“) for clockwise
operation. You can now e.g. tighten screws.
Push the bolt back towards the „R“ marking
(„Reverse / Release“) so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.
Summary of Contents for PDSS 310 A3
Page 4: ......
