5. Proper use
The fretsaw was designed to cut square-edged
timber or wood-like workpieces such as
Plexiglas, glass fiber reinforced plastic, foam,
rubber, leather, and cork. Do not use this saw to
cut round materials. Round materials can easily
become jammed.
Risk of injury! Parts can be
catapulted!
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
■
The equipment is to be operated only with
suitable saw blades. It is prohibited to use
any type of cutting-off wheel.
■
To use the equipment properly you must
also observe the safety information, the
assembly instructions and the operating
instructions to be found in this manual.
■
All persons who use and service the
equipment have to be acquainted with these
operating instructions and must be informed
about the equipment’s potential hazards.
■
It is also imperative to observe the accident
prevention regulations in force in your area.
■
The same applies for the general rules of
health and safety at work.
■
The manufacturer will not be liable for any
changes made to the equipment nor for any
damage resulting from such changes.
Residual risks
Even if you use this electric power tool in
accordance to instructions, certain residual
risks cannot be eliminated. The following
hazards may arise in connection with the
equipment’s construction and layout:
■
Lung damage if no suitable protective dust
mask is applied
■
Damage to hearing if no suitable ear
protection is applied
■
Contact with the blade in the uncovered
cutting zone
■
Injuries (cuts) when changing the blade
■
Crushed fingers
■
Kickback
■
Tilting of the workpiece due to inadequate
support
■
Touching the blade
■
Catapulting of pieces of timber and
workpieces
6. Technical data
Mains voltage:
230 V ~ 50 Hz
Power input:
120 W
Operating mode:
S6 30%
Power input:
80 W
Operating mode:
S2 20 min
Idle speed n
0
:
400 - 1,600 rpm
Protection type:
IP 20
Stroke: 21
mm
Base area:
410 x 245 mm
Tilting range of table:
0° to 45° to the left
Table size:
410 x 253 mm
Length of saw blade:
134 mm
Reach: 406
mm
Max. cutting height at 90°:
57 mm
Max. cutting height at 45°:
32 mm
Weight:
approx. 10.5 kg
Operating mode S6 30%:
Continuous operation with idling (cycle time 10
minutes). To ensure that the motor does not
become excessively hot, it may only be
operated for 30% of the cycle at the specified
rating and must then be allowed to idle for 70%
of the cycle.
GB/
MT
54
Anleitung_LB5_4309025:_ 25.05.2011 14:03 Uhr Seite 54
