Parkside PAT 20-LI A 1, Translation Of The Original Instructions

Page: 33 / 53

PAT 20-Li A1
GB
│
MT
│ 29 ■
5 . Use and handling of the cordless
electrical power tool
a) Charge a rechargeable battery unit using
only the charger recommended by the manu­
facturer.
Chargers are often designed for a
particular type of rechargeable battery unit .
There is the danger of fire if other types of
rechargeable battery units are used .
b) Only the rechargeable battery units supplied
are to be used with an electrical power tool.
The use of other rechargeable battery units may
lead to the danger of injury or fire .
c) When they are not being used, store re­
chargeable battery units away from paper­
clips, coins, keys, nails, screws or other small
metal objects that could cause the contacts
to be bridged.
Short-circuiting the contacts of
a rechargeable battery unit may result in heat
damage or fire .
d) Fluids may leak out of rechargeable battery
units if they are misused. If this happens,
avoid contact with the fluid. If contact occurs,
flush the affected area with water. Seek addi­
tional medical help if any of the fluid gets into
your eyes.
Escaping battery fluid may cause
skin irritation or burns .
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable bat-
teries.
Protect the rechargeable battery
from heat, for example from continu-
ous exposure to sunlight, fire, water
and moisture.
There is a risk of explo-
sion .
6 . Service
a) Have your power tool serviced by a qualified
repair person using only identical replace­
ment parts.
This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for electric staple guns
■ Always assume that the power tool con-
tains staples.
Careless handling of the tacker
can lead to unexpected ejection of staples
which could cause injuries .
■
Never aim the power tool at yourself or
other people in the vicinity.
Unintended
triggering will cause a staple to be shot out,
which can lead to injuries .
■ Do not activate the power tool until it is
pressed firmly against the workpiece.
If the
power tool is not in contact with the workpiece
the staple can rebound off the fastening point .
■ Disconnect the power tool from the mains
or battery if a staple becomes jammed
in the power tool.
If the tacker is connected,
it could be unintentionally activated while re-
moving a jammed staple .
■
Be careful when removing a jammed
staple.
The system may be under tension and
the staple could be forcefully ejected while you
attempt to unblock the jam .