Parkside PAHE 20-Li B2, Original Instructions Manual

Page: 20 / 160

20
GB CY
Service intervals table
Machine part Action
Before each
use
After 10 hrs of use
Complete machine
Check condition, replace da-
maged parts as needed

Accessible screws
and nuts
Tighten

Saw chain
Check, apply oil, reground or
replace

Blade bar Check, rotate, clean, apply oil
 
Sharpening the cutting teeth
Have the saw chain sharpened by a spe-
cialist, or proceed in accordance with the
operating manual for your saw chain shar-
pening device. Sharpening a saw chain
requires some practice. Replacing the saw
chain is preferable in case of doubt.
Changing the saw chain
Wear gloves when handling the
saw chain.
Never attach a new saw chain
onto worn teeth, or onto a dama-
ged or worn blade bar.
1. Switch off the device and remove the
batteries.
2. Remove the sprocket cover (5) by loos-
ening the wing nut (3) first
.
3. Remove the old saw chain (2).
The mounting and tensioning of the new
saw chain is described in the “Assembly -
Mounting the saw chain” and “Tensioning
the saw chain” section.
Servicing the blade bar
The blade bar has to be reversed every
8-10 operational hours in order to ensure
even wear (see the “Servicing and clea-
ning - rotating the blade bar” chapter”).
1. Switch off the device and remove the
battery.
2. Remove the sprocket cover
(5), the saw chain (2) and the blade
bar (1).
3. Check the blade bar (1) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passage (23) to ensure
fault-free, automatic oiling of the saw
chain during operation.
5. Mount the blade bar, saw chain and
sprocket cover and retighten the saw
chain (see the “Assembly” chapter).
Turning the blade bar
Wear gloves when handling the
saw chain.
1. Switch off the device and remove the
battery.
2. Remove the sprocket cover (5) by loos-
ening the wing nut (3) first
.