Parkside PABSP 20-Li B2, Operation And Safety Notes

Page: 36 / 132

35 GB/IE
2
nd
gear:
Suitable for: Drilling
Speed: High
Torque: Low
˜
Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch 5 until the product has come to
a standstill .
¾
Change the direction of rotation by pressing
the rotation direction switch 5 towards the
left or right (fig . G) .
¾
When the rotation direction switch 5 is in
the middle position, the on/off switch 6 is
locked .
˜
Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded .
¾
The torque can be adjusted by turning the
torque sleeve 3 (fig . H) .
¾
Small screws or soft materials: Select a low
level .
¾
Large screws, hard materials or removing
screws: Select a high level .
¾
For drilling operation: Turn the torque sleeve
3 to the position .
˜
Switching on and off
NOTE
The on/off switch 6 cannot be locked .
¾
Switching on: Press and hold the on/off
switch 6 .
Regulate the speed as required (see “Speed
control”) (fig . I) .
¾
Switching off: Release the on/off switch
6 .
˜
Speed control
¾
By using the on/off switch 6 , you can
progressively control the speed:
Pressure Speed
Gentle pressure: Lower speed
Greater pressure: Higher speed
˜
LED work light
This product is equipped with a LED work light
11 to illuminate the immediate working area to
improve visibility in poorly lit areas .
¾
The LED work light 11 lights up automatically
as soon as the product is switched on .
NOTE
u
The LED work light 11 stays on for an
additional approx . 10 seconds after
switching off the product .
˜
Trial run
NOTE
u
Always carry out a no-load trial run before
starting work and after every accessory
tool replacement . Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises .