Parkside PABH 20-Li A1, Original Instructions Manual

Page: 10 / 40

PABH 20-Li A1 GB
│
IE
│
CY
│
7 ■
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch into the
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack:
♦ Press the release button and remove the
battery pack .
Operation
NOTE
► Push the rotation direction switch into
the middle position before carrying out
any work on the power tool (e.g. mainten-
ance, tool-changing, etc.) as well as during
carriage and storage of the power tool.
Unintentional activation of the On/Off
switch can result in injury.
Selecting a tool
■ For hammer drilling, you will need an SDS-plus
drilling tool.
■ For standard drilling in wood, metal, ceramics
and plastic, you can use an appropriate SDS-
plus drilling tool or a tool with a hexagonal
shank.
■ For screwing, use the screwdriver bits that
you can attach using the SDS bit adapter .
Tool-changing
■ You can use the SDS-plus tool holder to
change tools quickly and easily without the
need for any additional tools.
■ The SDS-plus drilling tool moves freely (depend-
ing on the system). This leads to a radial run-out
deviation while idling. This has no effect on the
accuracy of the drill hole as the drill centres
itself during drilling.
■ The SDS-plus bit adapter can also hold dif-
ferent types of drills with hexagonal shanks.
■ The dust protection cap largely prevents the
entry of drilling dust into tool holder during
operation. Ensure that the dust protection cap
does not get damaged when fitting tools.
NOTE
► A damaged dust protection cap must
be replaced immediately. We recommend
having this done by a customer service
workshop.
Fitting an SDS tool
♦ Pull the locking sleeve backwards and insert
the tool in the tool holder .
♦ Release the locking sleeve . This locks the
holder. Check that the tool is properly locked by
pulling it. The system has radial play because of
the design.
Removing an SDS tool
♦ Pull the locking sleeve backwards and re-
move the tool.
Fitting a tool with a hexagonal shank
♦ Pull the locking sleeve backwards and insert
the SDS bit adapter in the tool holder .
♦ Release the locking sleeve . This locks the
holder. Check that the SDS bit adapter is
properly locked by pulling it. The SDS bit ad-
apter has radial play because of the design.
♦ Pull the locking sleeve of the SDS bit ad-
apter backwards and insert the tool with the
hexagonal shank in the tool holder .