Parkside KH 3163 ELECTRIC SCRAPER, Operation And Safety Notes

Page: 6 / 58

8 GB/IE/CY
General safety advice for electrical power tools
plugs and matching sockets reduce the risk of
electric shock.
b) avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
There is an increased risk of electric shock if
your body is earthed.
c) Keep the device away from
rain or moisture.
Water entering
an electrical device increases the
risk of electric shock.
d)
Do not use the mains lead for
any purpose for which it was
not intended, e.g. to carry the
device, to hang up the device or to pull
the mains plug out of the mains socket.
Keep the mains lead away from heat,
oil, sharp edges or moving parts of the
device.
Damaged or tangled mains leads
increase the risk of electric shock.
e) When working outdoors with an electri-
cal power tool always use extension ca-
bles that are also approved for use out-
doors.
The use of an extension cable suitable for
outdoor use reduces the risk of electric shock.
f) Use a residual current device (rCD)
for protection if operating the electri-
cal power tool in a moist environ-
ment is unavoidable.
The use of an RCD
reduces the risk of electric shock.
3. Personal safety
a)
remain alert at all times, watch what
you are doing and always proceed
with caution. Do not use the device if
you are tired or under the influence
of drugs, alcohol or medication.
One
moment of carelessness when using the device
can lead to serious injury.
b) Wear personal protective
equipment and always wear
safety glasses.
The wearing of
personal protective equipment such as dust
masks, non-slip safety shoes, safety helmets or
ear protectors, appropriate to the type of elec-
trical power tool used and work undertaken,
reduces the risk of injury.
c) avoid unintentional operation of the
device. Check that the electrical pow-
er tool is switched off before you
connect it to the mains, pick it up or
carry it.
Accidents can happen if you carry
the device with your finger on the ON / OFF
switch or with the device switched on.
d) remove any setting tools or span-
ners before you switch the device on.
A tool or spanner left attached to a rotating
part of a device can lead to injury.
e)
avoid placing your body in an unnat-
ural position. Keep proper footing
and balance at all times.
By doing this
you will be in a better position to control the
device in unforeseen circumstances.
f) Wear suitable clothing. Do not wear
loose clothing or jewellery. Keep your
hair, clothing and gloves clear of mov-
ing parts.
Loose clothing, jewellery or long
hair can become trapped in moving parts.
g) If vacuum dust extraction and col-
lection devices are fitted do not forget
to check that they are properly con-
nected and correctly used.
The use of
these devices reduces the hazard presented by
dust.
4. Careful handling and use of
electrical power tools
a)
Do not overload the device. always
use an electrical power tool that is
intended for the task you are under-
taking.
By using the right electrical power
tool for the job you will work more safely and
achieve a better result.
b) Do not use an electrical power tool if
its switch is defective.
An electrical power
tool that can no longer be switched on and off
is dangerous and must be repaired.
c) Pull the mains plug out of the socket
before you make any adjustments to
the device, change accessories or