Parkside 380747 2110, Translation Of The Original Instructions

Page: 17 / 268

PAHE 20-Li C3 ■ 12 │
GB
│
IE
Mounting the saw chain and blade
WARNING!
► Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
► The sprocket cover together with the chain
tensioning ring and the fixing screw
are not pre-assembled on the appliance at
delivery.
► The turning of the blade is not intended by
the manufacturer.
► The chain travel direction on the
blade must be adhered to every assembly.
♦ Place the saw chain on the blade .
Ensure that
the saw chain is running in
the correct direction (see Fig. B).
♦ Attach the blade with the labelling facing
upwards and guide the saw chain around
the chain sprocket .
The guide rail must be above the blade
guide (see Fig. C).
♦ Put the sprocket cover on.
♦ Tighten the fixing screw slightly.
♦ Now, tighten the saw chain (see section
Tightening and checking the saw chain).
♦ Tighten the fixing screw completely.
Tightening and checking
the saw chain
WARNING!
► Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦ Undo the fixing screw .
♦ Turn the chain tensioning ring in a clockwise
direction to increase the tension.
♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain can be drawn
over the blade by hand .
♦ Now tighten the fixing screw completely.
NOTE
► A new saw chain stretches and must be
tightened more regularly.
Lubricating the chain
♦ Remove the oil filler cap .
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain runs dry, the cutting
equipment may become irreparably
damaged within a short time. Always check
chain lubrication and oil level in the tank
before starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
Mounting the saw head on the
telescopic handle
♦ Place the lower end of the saw head
13a
on the
upper end of the telescopic handle so that
the saw head
13a
can be pushed through as far
as the black plastic ring. Make sure that the
groove and the recess interlock with each other.
♦ Tighten the red connecting piece
1a
by turning
it towards the symbol on the saw head
13a
.
Sharpening the saw chain
NOTE
► You will find detailed information on
sharpening in the sharpening set.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing
the work, the saw chain should be
replaced.