Parkside 364705 2101, Translation Of The Original Instructions

Page: 12 / 41

PMB 1100 B2 ■ 8
│
GB
│
IE
│
NI
│
CY
Adjusting the workpiece stop
■ During normal operation, the workpiece stop
must be fixed in the lowest position.
♦ If the workpiece stop gets in the way when
sawing, you can undo the workpiece stop
screw to remove it. Use the supplied hex
key to do this. In this way, you can adjust the
workpiece stop upwards. Fix the workpiece
stop in place again using the workpiece stop
screw .
Changing the saw blade
WARNING! RISK OF INJURY!
► Wear protective gloves to avoid injury.
NOTE
► You can reorder saw blades via our service
hotline.
♦ Release the saw blade clamping lever by
turning it anticlockwise .
♦ Remove the two locking screws with the
supplied small hex key . Remove the two
protective covers .
♦ Carefully remove the saw blade . Start at the
guide rollers (see fig. B on the fold-out
page).
♦ Remove any sawdust with a brush or
compressed air.
♦ Slide the saw blade into the guide rollers
with the saw teeth pointing upwards. Make sure
that the guide rollers completely grip the
saw blade .
NOTE
► Make sure that the direction arrow on the
saw blade (if any) is the same as the one
on the rubber wheels .
♦ Insert the saw blade around the two rubber
wheels.
♦ Retighten the saw blade clamping lever by
turning it clockwise again.
♦ Replace the two protective covers .
WARNING! RISK OF INJURY!
►
Only operate the appliance with the
protective covers fitted !
♦ Perform a test run by briefly switching the appli-
ance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
► Keep your body away from the sawing
area during the test run!
Use
Switching the appliance on and off
Switching on
♦ Hold down the On/Off switch .
Switching off
♦ Release the On/Off switch .
Switching the work lamp on and off
Switching on
♦ Move the light switch to position I.
The work lamp lights up.
Switching off
♦ Move the light switch to position 0.
The work lamp goes out.
Setting rotational speed
♦ Adjust the speed setting wheel to a position
between 1 and 6.
IB_364705_PMB1100B2_IE_NI_CY.indb 8 07.04.2021 15:07:08