![background image](http://html1.mh-extra.com/html/parkside/359201-2110/359201-2110_translation-of-the-original-instructions_758353012.webp)
PMKA 20-Li A1
■
8
│
GB
│
IE
CAUTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦
Push the battery pack into the appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Inserting/removing the battery pack
Inserting the battery pack
♦
Push the battery pack into the handle until it
clicks into place.
Removing the battery pack
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
WARNING! RISK OF INJURY!
►
Before doing any work on the device, switch
it off and remove the battery.
Changing the die holder position
(see fig. A)
The die position can be adjusted by 360°. Four
working positions offset by 90° are specified.
The working positions can be set as follows:
♦
Undo the hex screw using the hex key
supplied.
♦
Turn the die holder into the desired working
position so that the respective hole in the die
holder faces towards the hex screw .
♦
Retighten the hex screw using the supplied
hex key .
♦
Rotate the die holder slightly to check
whether it is fixed in the correct position.
Permissible material thickness
The maximum cutting capacity depends on the
material quality and strength. The measuring
grooves and on the die holder serve as
a thickness gauge for the permissible cutting thick-
ness. Never cut material thicknesses greater than
those specified in the technical data.
Fitting and removing the grooved pin
and the die holder (see figs. B + C)
♦
To remove the grooved pin and the die
holder , undo the hex screw using the
supplied hex key .
♦
Pull the die holder from the appliance.
♦
Undo the hex screw using the supplied hex
key so you can remove the grooved pin
from the tool holder .
♦
Insert the new supplied grooved pin into the
tool holder so that the hole in the grooved
pin is facing towards the hex screw .
♦
Tighten the hex screw , to fasten the grooved
pin in place.
♦
Guide and replace the die holder above
the tool holder in the appliance.
♦
Turn the die holder into the desired working
position so that the respective hole in the die
holder faces towards the hex screw .
♦
Retighten the hex screw using the supplied
hex key .
♦
Rotate the die holder slightly to check
whether it is fixed in the correct position.
Summary of Contents for 359201 2110
