Parkside 353555 2010, Translation Of The Original Instructions

Page: 12 / 46

GB
│
IE
│
NI
│
CY
│ 9 ■ PHKS 1350 C2
Changing the batteries
■ Open the cover of the battery compartment
with a suitable Philips screwdriver .
■ Remove the spent batteries .
■ Insert two new 1 .5 V alkaline button cells (type
AG 13/LR 44, e .g . GPA 76) observing the
correct polarity and screw the battery compart-
ment cover firmly closed .
CAUTION!
► If operating and adjustment equipment is
used or procedures other than those specified
here are carried out, this may result in
hazardous radiation exposure .
Original accessories/additional
equipment
■ Only use the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.
Before use
Check that the blade guard is
functioning correctly
WARNING! RISK OF INJURY!
■ Switch off the appliance and pull out the
power plug before starting any work on
the appliance .
■ Make sure that all moving parts of the blade
guard move freely without jamming and all
devices designed to cover the saw blade are
working correctly .
■ Activate the blade guard only using the
release lever for the blade guard .
♦ Pull the release lever for the blade guard
all the way back .
When you let go of the release lever for the
blade guard , the blade guard must
move freely back to its starting position .
Initial operation
The PHKS 1350 C2 circular
saw has Intelligent Power Control . This automatic
power delivery system ensures that for a particular
speed range the power output remains constant
when working on harder and more resistant mate-
rials .
Fitting/changing the saw blade
NOTE
► All blades used should conform to EN 847-1 .
■ Use only saw blade with diameters
corresponding to the label on the saw .
Always pull out the plug from the mains before
changing the saw blade !
1 . Set the cutting depth (using the locking
screw ) to the minimum position, 0 mm .
2 . Swing the blade guard back using the
release lever and put the device down .
3 . Press the spindle lock button (until it
engages) and use the Allen key to release
the clamping screw/washer . Now remover
the clamping screw/washer and the
clamping flange (see also Fig . A) .
Fig. A: Changing the saw blade
4 . Remove saw blade .
5 . Fitting a saw blade is carried out in the
reverse order .
6 . Press the spindle lock button (until it
engages) and use the Allen key to tighten
the clamping screw/washer .