Parkside 353555 2010, Translation Of The Original Instructions

Page: 14 / 46

GB
│
IE
│
NI
│
CY
│ 11 ■ PHKS 1350 C2
Switching the laser on and off
Switching on
♦ Press the ON/OFF switch laser .
Switching off
♦ Press the ON/OFF switch laser .
NOTE
► If the batteries are spent, replace them with
two new 1 .5 V alkaline button cells (type
AG 13/LR 44, e .g . GPA 76) .
Set rotational speed
■ Turn the adjusting wheel to the desired
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/
6 = highest rotational speed):
Use the following suggested settings or set the
rotational speed on the adjusting wheel as
required .
Material
Rotational
speed
setting
Cross cuts & longitudinal cuts in
hard and soft wood (solid wood)
6
Chipboard, fibre board 6
Core board, plywood 6
Coated and veneered boards 6
PVC sheets 3 – 5
Acrylic glass sheets, perspex 2 – 4
Aluminium plate 4 – 6
Aluminium profile 4 – 6
Plaster board 1 – 2
Stone wool board 1 – 2
Cement-bonded particle board 1 – 2
Tips and tricks
■ Avoid damaging the cutting edge of sensitive
materials, e .g . coated chipboards or doors, by
sticking masking tape along the cutting line .
Another benefit of this is that it is easier to mark
a line on the tape than on a shiny surface . An
even more effective method of protecting the
cutting edges is to clamp a thin piece of wood
along the cutting line (this wood is also sawn) .
Maintenance and Cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ To clean the casing, use a soft dry cloth .
■ The blade guard must always move freely and
close automatically . Therefore, keep the area
around the blade guard clean at all times .
Remove dust and chips by blowing them out
with compressed air or with a brush .
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or his representative in order to avoid safety
hazards .