Parkside 351903_2007, Translation Of The Original Instructions

Page: 40 / 190

40
GB IE
Troubleshooting
Switch off the tool and remove the battery before you service the tool.
Risk of electric shock!
Problems Possible Cause Error correction
Device doesn‘t start
Discharge the battery ( 9)
Charge the battery ( 9)
(observe the separate operating
instructions for the battery and
charger)
Battery ( 9) not inserted
Insert the battery ( 9)
(see “Operation”)
On/off switch ( 5) may be
defective
Repair by Customer Care
Engine faulty
Grinding tool does
not move although
the engine is run-
ning
Clamping screw is loose
Tighten clamping screw (see
„Changing disc“)
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Remove blockages
Engine is slower
and stops Device is overloaded through
workpiece
Reduce pressure on grinding tool
Workpiece unsuitable
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Clamping screw is loose
Tighten clamping screw (see
„Changing disc“)
Cutting/grinding disc is
defective
Change grinding disc