Parkside 351903_2007, Translation Of The Original Instructions

Page: 35 / 190

35
IE GB
Operation
Caution!
Risk of injury!
- Only use grinding tools which bear in-
formation about the manufacturer, type
of binding, dimension and permitted
number of revolutions.
- Only use grinding discs where the
printed rotational speed is at least as
high as what has been specified on the
name plate of the device.
- Do not use any broken, cracked, or oth-
erwise damaged grinding discs.
- Never operate the device without pro-
tective equipment.
- Support the plates or workpieces in or-
der to reduce the risk of kickback from
a jammed cutting disc.
Large workpiec-
es may bend under their own weight.
The workpiece must be supported on
both sides of the disc, not only near the
cutting disc, but also at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Information
on replacement:
• Never operate the device without pro-
tective equipment.
• Ensure that the rotation speed stated on
the grinding disc ( 11) is the same
or higher than the nominal rotation
speed of the device.
• Ensure that the grinding disc dimen-
sions match those of the device.
• Only use flawless grinding discs (ring
-
ing test: when you strike the grinding
disc with a plastic hammer, it results in
a clear sound).
• Never re-drill a locating hole which is
too small to make it larger.
• Never use separate bushings or adapt-
ers in order to make grinding discs with
a hole that is too large fit the device.
• Do not use any saw blades.
• To clamp the grinding tools only use the
clamping flange provided. The pads
between the clamping flange and the
grinding tools must be made of elastic
materials e.g., rubber, soft cardboard
etc.
Switch off the tool and remove the
battery before you service the tool.
Wear protective gloves when
changing the cutting/grinding discs
in order to avoid injuries from cuts.
The clamping screw ( 3) must not
be too tight in order to avoid break-
ing the cutting/grinding disc
(
2).
Inserting/removing the
rechargeable battery
1. To insert the battery (9) into the device,
push the battery along the guide rails
into the device. You will hear them click
into place.
2. To remove the battery (9) from the de-
vice, press the release button (8) on the
battery and pull the battery out.
Checking the battery charge
level
The battery’s ( 9) charge level is indi-
cated by the charge state indicator ( 6).
• The LEDs indicate the battery’s charge
level, when the device is in operation.
To switch on, push the pressure point
on the on/off switch (
5a) down-