Parkside 339966-1910, Translation Of The Original Instructions

Page: 38 / 147

PDFW 120 A2 ■ 34
│
GB
│
IE
Fitting tools onto the flexible shaft
♦ Push the black collar all the way back onto
the flexible shaft to lock the spindle. Note
that the collet chuck mount is loosened in an
anticlockwise direction. Hold the black collar
in this position.
♦ Use the combination spanner to undo the
collet chuck mount on the flexible shaft .
♦ Fit the tool and screw the collet chuck mount
back into place.
♦ Release the black collar .
Changing the collet chuck
You can change the collet chuck if the shaft
diameter of the tool you want to use is different.
♦ Push the black collar all the way back onto
the flexible shaft to lock the spindle. Note
that the collet chuck mount is loosened in an
anticlockwise direction. Hold the black collar
in this position.
♦ Use the combination spanner to undo the
collet chuck mount on the flexible shaft .
Unscrew the collet chuck mount .
♦ Remove the collet chuck and replace it with
a collet chuck with the desired diameter.
♦ Replace the collet chuck mount back on the
flexible shaft . Screw the collet chuck mount
tight using the combination spanner .
♦ Release the black collar .
Using the work arbor for cutting discs
♦ Use the screw driver side of the combination
spanner to undo and tighten the screw of the
work arbor for cutting discs .
♦ Fit the work arbor for cutting discs as
described into the flexible shaft .
♦ Use the combination spanner to undo the
screw on the work arbor for cutting discs .
♦ Fit the desired cutting disc / onto the screw
between the two washers.
♦ Use the combination spanner to tighten the
screw on the work arbor for cutting discs .
Use the work arbor for polishing felts
♦ Screw the tip of the work arbor for polishing
felts clockwise into the corresponding hole
in the polishing felts / .
♦ Fit the work arbor for polishing felts as
described into the flexible shaft .
Using the work arbor for abrasive belts
♦ Push the required abrasive belt / com-
pletely onto the corresponding work arbor for
abrasive belts / .
♦ Use the combination spanner to tighten the
screw on the work arbor / to fasten the
abrasive belts.
♦ Fit the work arbor for abrasive belts / as
described into the flexible shaft .
Notes on working with materials/
tools/speed range
■ Never use the appliance for other purposes
and only use original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
■ Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium and copper
by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the medium speed range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on.