PFBS 160 B2
DE
│
AT
│
CH
│
83
■
Griffring mit LED-Licht verwenden
♦
Schrauben Sie die Überwurfmutter gegen den
Uhrzeigersinn vom Gewinde ab .
♦
Schrauben Sie den Griffring mit LED-Licht im
Uhrzeigersinn auf das Gewinde .
♦
Bringen Sie den EIN-/AUS-Schalter des LED-
Lichts in Position „I“, um es einzuschalten
(siehe Abb . C) .
♦
Bringen Sie den EIN-/AUS-Schalter des LED-
Lichts in Position „O“, um es wieder auszu-
schalten .
Hinweise zu Materialbearbeitung/
Werkzeug /Drehzahlbereich
■
Verwenden Sie die Fräsbits zur Bearbeitung von
Holz, Kunststoff und Rigips unter Höchstdreh-
zahl .
■
Ermitteln Sie den Drehzahlbereich zur Bearbei-
tung von Zink, Zinklegierungen, Aluminium, Kup-
fer und Blei durch Versuche an Probestücken .
■
Bearbeiten Sie Kunststoffe und Materialien mit
niedrigem Schmelzpunkt im niedrigen Drehzahl-
bereich .
■
Bearbeiten Sie Holz mit hohen Drehzahlen .
■
Führen Sie Reinigungs-, Polier- und Schwabbel-
arbeiten im mittleren Drehzahlbereich durch .
HINWEIS
►
Der Fräsbit ist nicht für Stahl und Eisen
geeignet . Geeignete Fräsbits sind im Handel
erhältlich .
Die nachfolgenden Angaben sind unverbindliche
Empfehlungen . Testen Sie beim praktischen Arbei-
ten auch selbst, welches Werkzeug und welche Ein-
stellung für das zu bearbeitende Material optimal
geeignet sind .
Geeignete Drehzahl einstellen:
Ziffer an der
Drehzahlregulie
rung
zu bearbeitendes Material
1
Kunststoff und Werkstoffe mit
niedrigem Schmelzpunkt
2–3
Gestein, Keramik
4
Weichholz, Metall
5
Hartholz
Max.
Stahl
Summary of Contents for 332006 1907
Page 3: ...C A B 14b...