PWS 230 D4
■
52
│
GB
│
MT
Permissible accessories
Max.
diameter
Ø (mm)
Max.
thickness
(mm)
Thread
size (mm)
Speed
(rpm)
Circumfer-
ential speed
(m/s)
Tool
Blade
guard
Cutting disc
230
3
M14
6500
80
Two-hole mounting
spanner
Yes
Roughing disc
230
6
M14
6500
80
Two-hole mounting
spanner
Yes
Storage and handling of the recommended accessory tools
■
Grinding tools are to be treated with care and transported carefully.
■
Grinding tools should be stored in such a way that they are not exposed to mechanical damage or
environmental influences (e.g. moisture).
Working procedures
NOTE
►
Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding:
Never use cutting discs
for rough grinding!
■
Move the angle grinder with moderate
pressure back and forth over the workpiece.
■
For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
Abrasive cutting:
Never use rough grinding
discs for cutting!
■
Use only tested fibre-reinforced cutting or
grinding discs
that are approved for a circum-
ferential speed of not less than 80 m/s.
CAUTION!
►
The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■
Secure the workpiece!
Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■
Always switch off the appliance before
putting it away and wait for the appliance to
come to a complete standstill.
■
Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out.
Move it into the OFF position. This
prevents an uncontrolled restart.
■
Use the appliance only for dry cutting or
sanding.
■
The additional handle must be mounted on
the appliance for all work.
■
Materials containing asbestos may not be
processed.
Asbestos is a known carcinogen.
Tip! This symbol indicates proper
behaviour.
