![background image](http://html1.mh-extra.com/html/parkside/321225-1901/321225-1901_manual_758325048.webp)
PSTD 800 B2
■
44
│
GB
│
MT
Initial operation
Fitting/changing the saw blade
Always remove the plug from the power socket
before working on the appliance.
♦
Remove the pivoting blade guard .
♦
Turn the quick-release chuck and hold it in
this position.
♦
Push the required saw blade into the quick-
release chuck as far as the limit stop.
♦
Release the quick-release chuck so that it
returns to its initial position. The saw blade is
now locked.
■
WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦
Replace the pivoting guard back onto the
appliance.
Fitting the rip fence
The rip fence can be fitted on the left or right of
the appliance.
♦
Undo both the clamping screws on the insertion
openings .
♦
Push the rip fence into the insertion openings .
♦
Retighten the two locking screws.
Connecting the sawdust extraction
device
♦
Push the reducer into the extraction nozzle
until it is secured.
♦
Attach an approved dust and sawdust extrac-
tor to the reducer or extraction nozzle
directly.
Fitting the sliding shoe
When working on sensitive surfaces, you can fit
the sliding shoe on the footplate to prevent
scratching the surface.
♦
Mount the sliding shoe onto the footplate
and press it up at the back until it clicks into
place on the footplate .
♦
To remove the sliding shoe , unfasten it at the
rear of the footplate and slide it off the front.
Fitting the splinter guard
The splinter guard can prevent fraying of the sur-
face while sawing wood . The splinter guard can
only be used for certain saw blade types, with the
sliding shoe and only for cutting angles of 0°.
♦
Press the splinter guard from below into the
sliding shoe (arrow facing upwards).
Adjusting the laser
♦
If the laser line is not vertical in the notch , you
can adjust it by adjusting the position of screw
.
Operation
Setting the cutting angle
♦
Undo the clamping screws with the hex
key and pull the footplate to the rear.
♦
Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the footplate .
Push the footplate to the front so that the
locking pin engages in the toothing .
♦
Retighten the clamping screws with the Hex
key .
NOTE
►
When using a cutting angle of 15°/30°/45°,
the pivoting blade guard and splinter guard
must be detached beforehand!
Setting the stroke rate
♦
Use the stroke rate adjusting wheel to set the
required stroke rate.
Adjusting the pendulum stroke
♦
You can use the pendulum stroke switch to
adjust the pendular movement of the saw blade
. You can achieve fine, clean-cut edges with-
out pendular movement (setting "0"). Deactivate
pendular movement when working on thin
workpieces. You can achieve an increasingly
fast work rate if the pendulum stroke is activated
(settings 1–3).