Parkside 307044, Original Instructions Manual

Page: 10 / 92

10
GB NI IE CY
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
• When operating a power tool
outdoors, use an extension cord
suitable for outdoor use.
Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
• If operating a power tool in a
damp location is unavoidable,
use a residual current device
(RCD) protected supply.
Use of an
RCD reduces the risk of electric shock.
Connect the appliance to a power
socket with a residual current circuit
breaker of rated residual current no
more than 30 mA.
• Use only approved power cable of
type H05RN-F, which are no more than
75 m in length and intended for use
outdoors. The conductor cross section
of the cord must be at least 2.5 mm
2 .
Always fully unroll a cable drum before
use. Check the power cord for damage.
Personal safety
CAUTION: In this way you avoid
accidents and injuries:
• Stay alert, watch what you are
doing and use common sense
when operating a power tool.
Do not use a power tool while
you are tired or under the inlu
-
ence of drugs, alcohol or medi-
cation.
A moment of inattention white
operating power tools may result in
serious personal injury.
• Wear personal protective equip-
ment and always wear safety
glasses.
Wearing personal protective
equipment such as nonslip safety boots,
in the presence of lammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the dust
or fumes.
• Keep children and bystanders
away while operating a power
tool.
Distractions can cause you to lose
control.
Electrical safety
CAUTION! The following states
how to avoid accidents and injuries
due to electric shock:
• Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapt-
er plugs with earthed (grounded)
power tools.
Unmodiied plugs and
matching outlets will reduce risk of elec-
tric shock
• Avoid body contact with
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators.
There is an in-
creased risk of electric shock if your
body is earthed or grounded.
• Do not expose power tools to
rain or wet conditions.
Water
entering a power tool will increase the
risk of electric shock.
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.
• If it is necessary to replace the connec-
tion cable, we recommend that this be
performed by the manufacturer or an
authorised representative (e.g. autho-
rised workshop, customer service, etc.).
• Do not abuse the cord. Never
use the cord for carrying, pulling
or unplugging the power tool.