Parkside 304732, Translation Of The Original Instructions

Page: 5 / 47

PMTS 180 A1 ■ 2
│
GB
│
IE
│
NI
│
CY
METAL CUT-OFF GRINDER
PMTS 180 A1
Introduction
Congratulations on the purchase of your new appli-
ance. You have chosen a high-quality product. The
operating instructions are part of this product. They
contain important information about safety, usage
and disposal. Before using the product, please
familiarise yourself with all operating and safety
instructions. Use the product only as described and
for the range of applications specified. Please also
pass these operating instructions on to any future
owner.
Intended use
The cut-off grinder is intended as a floor-mounted
appliance for making straight longitudinal cuts at
up to 45° using cutting discs in steel, nonferrous
metals, cast iron and iron profiles without the use
of water.
Any other uses of or modifications to the machine
are deemed to be improper usage and may result
in serious physical injury.
Not for commercial use.
Features
ON/OFF switch
Clamping flange (inside)
Spindle lock
Cutting disc
Rapid adjustment
Vice
Drillholes
Cutting angle adjustment
Transport safety device
Cutting depth adjustment
Motor unit
Handle
Figure A:
Pendulum cover
Protective cover
14a
Integrated carrying handle
Mounting screws
Figure B:
Clamping flange (outside)
Plain washer
Fixing nut
Figure C:
Hex key (large)
Hex key (small)
Package contents
1 metal cut-off grinder PMTS 180 A1
1 cutting disc Ø 180 mm (pre-fitted)
2 Hex keys
1 set of operating instructions
Technical data
Rated voltage: 230 V ∼, 50 Hz
(alternating current)
Rated power consumption: 1280 W
Rated idle speed:
n
0
7700 rpm
Cutting disc mounting: ø 22.23 mm
Thread size: M8
Maximum speed
of the cutting disc: 8500
rpm