PDSS 16 A1
GB
│
IE
│
NI
│
21
■
■
If the tool is exhibiting excessive vibration levels, the cause of the
vibrations must be identified and repaired.
■
Use only the genuine replacement parts recommended by the
manufacturer, otherwise you could put users at risk. In doubt,
contact the Service Centre.
■
Clean the tool with a soft, dry cloth only.
■
Never use sharp or abrasive cleaning agents under any circum-
stances.
Troubleshooting
Fault
Possible cause
Remedy
Speed too slow, air
escapes from the
outlet.
Motor parts
jamming due to
dirt.
Check the pressure
supply filter for con-
tamination.
Pressure supply
too low.
Check the pressure
supply filter for con-
tamination.
Lubricate the tool
as described in the
instructions.
If necessary, repeat
the steps outlined
above.
Tool does not move;
compressed air
escapes completely
through the outlet.
Motor is jammed
due to material
build-up.
Lubricate the tool
as described in the
instructions.
Summary of Contents for 304725
Page 3: ......
