Parkray Inset Chevin 20B, Installation And Operating Instructions Manual, Page: 15 / 18

JINCHW09 Rev A 12/05/14
Rope - Check the rope around the door. If rope is
becoming detached, use Parkray Ltd rope glue to
reattach it. If the rope is in a poor condition, a
replacement rope kit may be ordered from the
Parkray Ltd spares range.
Chimney & Flueways - It is important that the
chimney, flueways and any connecting flue pipe
are swept regularly. This means at least once a
year for smokeless fuels and at least twice a year
for wood and other fuels.
The baffle will need to be removed from its
supports in order to sweep the chimney (see
‘Removing internal components’ instructions).
Only wire-centred sweeps’ brushes fitted with a
guide wheel should be used.
If it is not possible to sweep all parts of the
chimney through the appliance, ensure there is
adequate access to cleaning doors.
Seasonal use - If the appliance has been unused
for a long period of time, such as during the spring
and summer months, the chimney should be
checked for potential obstructions by a competent
person before lighting the stove.
Gaskets - all gaskets used on this appliance are
produced from a heat resistant material called
Manniglas. The glass gasket will have to be
replaced when a new piece of glass is fitted as the
gaskets become brittle after firing the stove. Over
time you may find that the gasket changes colour.
This is due to a reduction in the pigment used in
the manufacture of the product and no cause for
concern.
De-ashing – De-ashing should be carried out on a
regular basis to avoid a build up of ash and ensure
sufficient primary air flow. Empty the ashpan
regularly to prevent ash reaching the underside of
the great bars.
When de-ashing ensure the
primary air channel at the front left of the stove is
clear of ash. If necessary this can be periodically
cleared with a vacuum cleaner. The primary air
cover can be removed by undoing the two screws
if required.
Trouble Shooting
F
IRE
W
ILL
N
OT
B
URN
Check that –

Chimneys and flueway are clear.

A suitable fuel is being used.

There is an adequate air supply into the room.

An extractor fan is not fitted in the same
room.

Flue draught is above minimum level (see
installation instructions).
F
IRE
B
LAZING
O
UT OF
C
ONTROL
Check that –

The door is tightly closed.

The air controls are in the closed position.

A suitable fuel is being used.

The glass is not loose.

The door rope seal is in good condition.
Flue draught is below maximum level (see
installation instructions).