ParkerVision CameraMan 1-CCD, Installation And Operation Manual

Page: 18 / 32

Installation and Startup
2-18
CameraMan

1-CCD Camera System Installation and Operations Manual
System Startup
Once you have made all of the necessary connections and configured the camera to your application, you are ready to
turn on the system.
Powering Up
To turn on the system:
1. Switch the Power button on the back of the camera to the ON
position. The camera should automatically enter its position-
calibration mode and stop at the zero-degree pan/tilt point.
2. Verify that the camera is now facing in the direction the FRONT
label was pointing during mounting. Refer to the "Mounting
Your CameraMan

Camera" topic in this section.
3. If you are using the optional Camera Control Keypad, make sure
its address is the same as the address on the camera. Also verify
that the camera's pan and tilt functions are working properly.
If the camera does not move, refer to the
Troubleshooting section of your Camera Control Keypad
or SHOT Director manual.
Setting Up Gen Lock
Refer to either of the following manuals for instructions on adjusting
gen lock timing parameters:
•
CameraMan

1-CCD Camera Control Keypad Operations
Manual
•
SHOT Director Installation and Operations Manual
PVI COM RS -2 32
AUX A
S-VI DEO
OUT
COM POSITE
VID EO OUT
DC
POWER
RS-48 5
POWER
POWER