Parker SMOKEETER SE-40, Owner'S Manual

Page: 14 / 32

10
Owner's Manual:
SMOKEETER® Electronic Air Cleaner
9.0 TROUBLESHOOTING TABLE
*
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
A. Control switch on, indicator lamp
off, blower operates.
1. Defective lamp.
2. Faulty connection to lamp.
3. Loss of high voltage.
4. Loss of continuity of high voltage.
1. Replace lamp.
2. Check connection to lamp.
3. Check power supply.
4. Refer to Problem “E”. Follow
steps 1-4.
B. Control switch on, indicator lamp
on, blower does not operate.
1. Motor faulty.
2. Foreign object blocking motor.
3. Faulty control switch
4. Connector not properly connected
at control switch
1. Replace motor.
2. Clean foreign object from motor.
3. Replace control switch.
4. Check connection at control switch.
C. Control switch on, motor and
lamp off.
1. Loss of input 115 VAC.
2. Safety interlock switch not engaged.
3. Safety interlock switch defective.
4. Control switch defective. 1. Determine loss of input voltage.
2. Engage safety interlock switch.
3. Replace safety interlock switch.
4. Replace control switch.
D. Motor operates on low or high
speed only.
1. Control switch defective. 1. Replace control switch.
E. Poor air quality.
1. Ionizer/collection cell/unicell dirty.
2. Ionizer/collection cell/unicell
malfunctioning.
3. Components installed backwards
or upside down.
4. High voltage contacts dirty.
5. Unit being operated on too low of
a speed.
6. Placement of unit not creating a
good air pattern.
1. Clean components.
2. Check for:
A. Foreign matter between plates.
B. Ionizer wire loose or broken.
C. Defects in insulators.
3. Install components as shown in
Section IX.
4. Clean high voltage contacts.
5. Increase blower speed.
6. Contact your local distributor or
Parker Hannifin.
F. Loss of high voltage output.
1. Loss of input 115 VAC.
2. Ionizer/collection cell/unicell
malfunctioning.
3. Power supply defective.
1. Determine loss of input voltage.
2. Check for:
A. Foreign matter between plates.
B. Ionizer wire loose or broken.
C. Defects in insulators.
3. Replace power supply.
* NOT SHOWN
+ SEE DETAIL PARTS LIST ON THE FOLLOWING PAGES