Chapter 2: Installing the PowerStation
Installing the XP PowerStation
XP Series PowerStation User Guide
2-12
Figure 2-8: Side View of a 10” PowerStation Mounted in an Enclosure
4
Tighten each of the mounting screws against the front of the
enclosure.
5
Torque the screws until the gasket is compressed by 50%.
Caution:
Do not over-tighten the screw/clamp assembly or you
may damage the monitor. However, under-tightening
may not guarantee a NEMA 4/4x seal.
6
Tighten the screws in a crosswise sequence to ensure a good seal
and prevent damage.
Note that tightening the bracket assembly may not ensure that the gasket
seal is totally depressed by the bezel and flush with the enclosure. Since a
proper NEMA 4/4x seal requires a 50% compression of the gasket, you
may see a small gap between the bezel and the enclosure.
Compress gasket
by 50%
Backshell
Bezel