Parker PowerStation XP Series, User Manual, Page: 22 / 65

Chapter 2: Installing the PowerStation Installing the XP PowerStation
XP Series PowerStation User Guide
2-11
Mounting a PowerStation With a 10” Display
If you are mounting a PowerStation with a 10” display, complete the
instructions below:
1
Slide the PowerStation into the cutout from the front.
2
Attach the 6 mounting clamps, with their screws to the back of the
unit in the spaces provided. Place 2 clamps on the top and bottom of
the monitor and 1 on each side.
The clamps secure to the unit using the sliding mechanism shown in
Figure 2-6.
Figure 2-6: Sliding Mechanism for 10” PowerStations
3
Insert the clamp into the wide end of the slot and slide it to the thin
end, refer to Figure 2-7.
Figure 2-7: Side View of a 10” PowerStation Mounting Clamp
Insert the mounting
clamp into these slots.
10” PowerStation
mounting clamp