25
EN
Insert cushion spigot (20) and install endcap
• Grease O-ring grooves (21), insert O-rings and grease them.
• Grease cushioning spigots (20).
• Place inlay nuts (26) in cushioning spigots with ridges upwards.
• Push cushioning pad (22) on to cushioning spigot (20), mind the correct installation position, bore hole
at the cushion spigot must not be closed.
Danger of injuries from sharp edges on Inner Sealing Band.
• Hold end of inner sealing band flush with the end of the barrel and slide piston to about 100 mm from
other end of cylinder barrel.
• At that end, push centring tool (see diagram) from above through hole in inner sealing band and hold it.
• Insert one cushioning spigot, angled slightly downwards, into cylinder barrel.
• Push cushioning spigot right in with gentle upward pressure and line it up with cylinder barrel,
• Remove centring tool.
• Place the insert nut (26) below the bore hole of the inner sealing band.
• Fit clamping piece (16) and clamping screw (15) but do not screw it down yet.
Information
See the table „Torque Moments for screws“ on page 24.
• Slide piston to about 100 mm from other end of cylinder barrel.
• Pull loose end of inner sealing band as far as possible to end of cylinder barrel.
• Push centring tool from above through hole in inner sealing band and hold it.
• Insert second cushioning spigot, angled slightly downwards, into cylinder barrel.
• Push cushioning spigot right in with gentle upward pressure and line it up with cylinder barrel.
• Remove centring tool.
• Position inlay nut (26) under hole in inner sealing band.
• Fit clamping piece (16) and clamping screw (15) but do not screw it down yet.
• Slide piston to the other end of cylinder barrel.
• Grease face of cushioning spigots and insert O-rings (18, 19).
• Fit end caps with air connection on the desired side.
• Tighten screws (36).
• Position inner sealing band (17) the same distance from both ends of cylinder barrel and tighten clamp-
ing screw (15) at this end.
• Slide piston to the other end position.
• Adjust position of clamping piece (16) so that inner sealing band (17) lies correctly along the whole
slot, without pretension or hanging loose.
• Tighten clamping screw (15) at this end too.
cleaning tool
with
centring tool
Inner Sealing Band (17)
Summary of Contents for OSP-P
Page 1: ...Modular Pneumatic Linear Drive System OSP P OSPP BG Operating Instructions ORIGA SYSTEM PLUS...
Page 35: ...35 EN 17 Spare Parts Lists 17 1 OSP P 10 17 2 OSP P 16 to 80 Item Number Item Number...
Page 36: ...36 Modular Pneumatic Linear Drive System OSP P OSPP BG 17 3 OSPP BG Item Number...
