3
Read This
2 Precautions
Instruction book, IQAN
2
Precautions
Work on the hydraulics control electronics may only be carried out by trained
personnel who are well-acquainted with the control system, the machine and its safety
regulations.
W
ARNING
Make sure that you have sufficient knowledge before designing, modifiying or
servicing the control system.
Read the relevant sections of this document before conducting any work on the control
system.
W
ARNING
This product is not field repairable.
N
OTICE
As much as possible of the welding work on the chassis should be done before the
installation of the system. If welding has to be done afterwards, the electrical
connections on the system must be disconnected from other equipment. The negative
cable must always be disconnected from the battery before disconnecting the positive
cable. The ground wire of the welder shall be positioned as close as possible to the
place of the welding. The cables on the welding unit shall never be placed near the
electrical wires of the control system.
Read This
Design of control system
W
ARNING
Risk of injury may be introduced by design of control system!
This product is designed to control hydraulic outputs. The control application must be
designed using basic safety principles so that unintentional movement is avoided.
The machine must be equipped with an emergency stop that stops all movement. Please
refer to section "Supply voltage".
Before you start
Read this document.
Read the IQANdesign software user manual section on 'application safety'.
