9
Mounting the unit
5 Mounting
Instruction book, IQAN- LC6-X05
5
Mounting
Mounting the unit
N
OTICE
The IQAN-LC6-X05 unit should be mounted according to the following instructions.
Mounting considerations
•
The control lever must be built in so that it is protected against direct pressurized
liquid spray (above flange) and excessive mechanical forces.
•
The machine manufacturer must consider the need of a protective catch, or similar,
to prevent unintentional working of the lever.
N
OTICE
Take careful consideration when positioning the unit.
•
Mount the unit so that it is not exposed to external heat, e.g. from the engine or
heater.
•
Mount the unit so there is no risk that the harness can be folded, crushed, worn or
damaged in any way.
•
Locate the harness so there is no pressure on the connector.
•
Use ergonomics. The control lever should be mounted at a height so that there is no
pressure on the driver's arm and shoulders. IQAN-LC6 should be mounted at an
angle so that the driver's wrist is held normally. The IQAN-LC6-X05 and a well
designed handle, such as the H1, combined with moveable arm rests, can provide
good ergonomics.
Ergonomic positioning of joystick
•
The control lever IQAN-LC6-X05 with 3rd axis is intended to be positioned so that
the rocker is manoeuvered with the thumb.
Actuating proportional rocker with thumb.
15
