Parker HLR Series, Mounting Instructions

Page: 27 / 56

Parker EME Installation / dismantelling of the drive
192-510201N1 HLR 2019-04
27
3.5 Installation / dismantelling of the drive
Before mounting or dismantelling the motor, de-energize it.
As standard, the HLR Linear actuators are equipped without drive flange. For the
gear attachment, one of the optionally available flange kits is needed (see
accessories in the HLR catalogue).
For dismantelling, the assembling sequence has to be carried out in reverse order.
Assembling sequence
Figure 5: Assembly of drive
Requirement: Axis is mounted in the system or fastened to another basic
structure.

Remove protection caps (see Figure 5, Pos. 1) of the respective side of the
deflection station.

Push clamp collar (please refer to Figure 5, Pos. 2) incl. clamping screw (please
refer to Figure 5 Pos. 3 onto the pulley. The clamping surface between pulley and
clamp collar must be free of oil and grease.
Clamp collar must abut to the pulley shoulder. The slot in the clamp collar must
be aligned to the slot in the pulley (see Figure 5 detailled view A).

Adjust clamp collar (please refer to Figure 5, Pos. 2) and pulley. Manually push
carriage so that the clamping screw (please refer to Figure 5, Pos. 3) is
accessible through the front mounting bore of the deflection station.

Pre-assemble drive package (motor with gears). Please observe operating
instructions/ manual of motor and gearbox.

Clean drive shaft and drive flange from anti corrosion agents, grease and oil.

Mount the HLR gear flange (see Figure 5, Pos. 4) to the gear output side using
the gear screws (see Figure 5, Pos. 5). For screws please refer to Table 5.