Parker CT3000, Operator'S Manual

Page: 7 / 39

USE TWO (2) WRENCHES WHEN CONNECTING DRYER TO PIPING. THIS WILL
PREVENT DAMAGE TO INTERNAL AIR LINES.
Electrical Connections
To be performed by a qualified person only. Risk of serious injury or
death.
Before connecting electrical power to the dryer check for correct voltage
and phase at the connection box.
All
units must be externally grounded to protect against severe electrical
shock.
Electrical Hookup
MODEL Wire Gauge Wiring
SC/CT 80 - 100 14 Gauge 3 prong cord included
SC/CT 130 - 3000 12 Gauge Hard wire
1. Remove electric box cover from inside unit.
2. Locate the wires.
3. Locate hole on side of box, place and tighten connector, run wires through
connector.
4. Using wire connectors, connect Black to Hot wire, White to Neutral and
Green to Ground wire.
5. Make sure no bare wire is exposed; replace box cover and screw closed.
Wire the dryer separately from the air compressor. The dryer must not
cycle with the air compressor.
Phase rotation is only important if the dryer has a 3 phase condenser
fan. Fans must pull air through condenser coil.
Crankcase heaters are pre-wired at the factory to line side of terminal box or
contactor. Heaters must be energized at all times, therefore the main
disconnect must be left on at all times except when servicing.