Chapter 1. Installation
5
PC Card Installation
St ep 1
Turn off the power to the computer.
St ep 2
Remove the computer's cover to access the internal slots where peripheral cards are added.
St ep 3
Select an expansion slot in your PC and remove the sheet metal bracket that covers the
associated external access slot. Save the screw. On IBM AT and IBM AT-compatible
computers, this is at the rear access panel where all external connections are made. This
bracket is replaced by the bracket on the end of the AT6n00 card.
St ep 4
Select a 16-bit slot to install the AT6n00 card.
CAUTION
While handling the AT6n00 card, be sure to observe proper grounding techniques to prevent
damage from electro-static discharge (ESD).
St ep 5
Insert the bottom corner of the AT6n00 PC card into the card guide slot near the front of the
computer. Ease both ends of the card simultaneously down into the computer until the card's
edge connector reaches the computer's mating connector (see drawing below). Adjust the card
until the edge connectors align and press it down into the mating connector.
Computer
Chassis
AT6n00
PC Card
PCA Card
Guide
Edge
Connector
Mounting
Screw
Mounting
Bracket
St ep 6
Using the screw that secured the original access slot cover bracket, fasten the AT6n00
mounting bracket to the computer chassis (see drawing above).
Summary of Contents for Compumotor AT6200
Page 5: ......
