CM2904 Instruction Book © 2009 - 2022 Parker-Hannifin Corporation Page 46 of 51
Start-Up
Start-Up Procedures
•
The engine for the hydraulic system's pump shall be in off position.
•
Make sure that all connectors are properly connected.
•
Turn on the control system.
•
Make sure that voltage is being supplied to all modules; the power-on LED’s
shall be illuminated on all modules. Also make sure that master is in contact
with all modules.
•
Make sure the emergency stop is functioning properly.
10.1.3. Start the System
Start the system as follows:
•
Start the engine for the hydraulic system's pump, assuming that the above
mentioned inspections have been carried out and shown correct values.
•
Calibrate and adjust input and output signals in your system according to the
instructions and check each and every output function carefully.
•
In addition to these measures, the machine shall also meet the machine
directives for the country in question.
