Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
Bulletin HY25-1396-M1/US
Wire Shift P.T.O.’s*
Owner’s Manual
Counter Shaft & Thrushaft
50
6. Determine from which direction the cable must come in order for the
unit to be disengaged when the knob is all the way in.
NOTE:
The shifter must always be installed in the following manner:
*CABLE IN: P.T.O. DISENGAGED(6A): OUT OF GEAR POSITION
CABLE OUT: P.T.O. ENGAGED(6B): IN GEAR POSITION
* The wire shift cable should be installed so that when the cable
(knob) is shifter, to the disengaged mode.
7. Install the wire control bracket found in either the 328380X or 328380-
1X wire control parts bag. [
7
]
8. Line the cable up with the wire control bracket and shifter lever
(disengaged position) on the P.T.O. cover assembly [8]
NOTE:
It may be necessary to change the position of the shifter lever
on the P.T.O. To do this, remove the shifter cover from the unit. This
will prevent the possible loss of the poppet and/or spring into the
transmission if the shifter post assembly should be pushed through
the cover when reinstalling the lever.
9. Shift the P.T.O. to the engaged position to see how much of the cable
casing must be cut to allow the lever enough travel to shift in and out
completely. The casing need only go just beyond the bracket,
whereas, the wire must be long enough to go through the swivel pin in
the shifter lever. [
9
]
NOTE:
In some instances the cable control may not be long enough.
Chelsea has available four longer lengths than the standard ten-foot cable.
These come in five foot increments (i.e., 328346-15X = 15-foot cable).
10.When the length of the casing has been determined, pull the wire
back through until the case can be cut without cutting the wire. Use a
hacksaw or heavy pair of side cutters to cut the casing.
NOTE:
The cable can be held by a bench vise as long as the jaws are
not tightened to the point where the case mushrooms. If a vise is not
accessible, a pair of vise grips will do the job.
Cable Control Installation Instructions * (Continued)
* All six bolt wire shifts with the exception of the reversible, dual shift
units, and some gear boxes.