33
4.
Connect Brine Discharge line with the supplied Brine Discharge tubing:
Outlet of
to
Inlet of
System Brine Discharge - TIE 1003
Thru Hull Discharge fitting
5.
Connect Product Water line with the supplied nylon tubing:
Outlet of
to
Inlet of
Potable Product Water from System
–
TIE 1002 & 1006
Potable Water Storage Tank
Note
Refer to Piping and Instrumentation Diagram for more details on plumbing.
Component Mounting Instructions
The mounting surfaces must be flat in order to avoid warping of brackets and frames. Use appropriate
shims on uneven surfaces to ensure that mounting of the system components does not cause bending or
warping.
1.
The Optional Sea Strainer is mounted below water level between the Inlet Sea Cock Valve and
Booster Pump. Allow at least 4 inches (10 cm) of clearance below the bowl to access the mesh
screen for cleaning or replacement.
2.
The Fresh Water Flush Filters Canister are mounted to the skid of the system. Allow at least 4
inches (10 cm) of clearance below the bowl for element replacement. Mount the Booster
Pumps near the system.
3.
The Booster Pump is mounted to a flat surface using the 4 supplied #10 x 1 1/4” long Type "A"
screws. The Booster Pump is mounted below water level to assist priming, and in an accessible
location to allow access for maintenance. Mount Booster Pump close to the Inlet Thru Hull/ Sea Cock
Valve and the Sea Strainer (if purchased). If the booster pump is mounted vertically, mount the
motor up and pump head down. Do not mount the pump head above the motor else motor
damage will occur if the pump or its fittings should develop a leak. The booster pump can also
be mounted on the Media filter Skid if purchased.
4.
The Pre-filter are mounted to the skid of the system.
5.
Ensure the Charcoal Filter are mounted to the skid of the system
6.
The system is mounted to a flat surface using four 1/4" x 2" Type "A" screws.
7.
Ensure the UV Sterilizer is plumbed directly after the Charcoal Filter if purchased.
8.
Attach the supplied tubing from the Brine/Reject Outlet (TIE 1003) to the boat
’
s Overboard
Discharge.
9.
Attach the supplied tubing from the Product Outlets (TIE 1002 & 1006) to the Product Water
Tank, use a TEE connection if necessary.
Summary of Contents for AQUA DUO A455C-2800
