RESTORING FACTORY CHANNEL SETTINGS
To restore the Park-Daddy® system to the Factory Channel Settings, follow these
steps:
1.
Make sure the RF Radio Receivers being programmed are within 50 feet of
the Infrared Head Units and no vehicles or any other objects are blocking
the Infrared Head Units.
2.
Using a thin object such as a toothpick, paper clip, etc., insert the object
into the Channel Programming Hole in Infrared Head Unit “A” as shown in
Figure 1
and hold the switch under the hole down for 10 seconds until the
LED on Infrared Head Unit “A” flashes Green rapidly and then rapidly
flashes
Red
.
3.
With the RF Radio Receiver powered up, press the (-) and (+) volume
buttons down at the same time for 5 seconds until the Status Indicator
flashes Red for 5 seconds and then illuminates Green. Once Green, the RF
Radio Receiver is programmed.
4.
Repeat the procedure in paragraph #3 for a second and any additional RF
Radio Receives being used with the reprogrammed system.
If other RF
Radio Receivers are not reprogrammed, they will not work with the
system.
5.
Once all the RF Radio Receivers are re-programmed, insert the thin object
you used before into the Channel Programming Hole in Infrared Head Unit
“A” and press the switch quickly once to put Infrared Head Unit back to the
normal operating mode. The Factory Channel Settings are now
programmed.
FOR MORE INFORMATION ON THE SETUP OF THIS PRODUCT, GO TO THE
INSTALLATION AND OPERATION INSTRUCTIONS VIDEO IN THE PARK-DADDY™
VIDEOS PAGE AT: WWW.PARK-DADDY.COM.
