T6T VHF 100 W Transmitter
Page 14
Operation
Back to Transmitter
Main Page
(4)
On completion, and if the interruptive test was initiated from the front panel, one of the following
screens will be shown.
(5)
Selecting OK takes the user back to the BIT screen.
(6)
Selecting OK takes the user back to the BIT screen. The user can then scroll through the screen
to check out transmitter parameters for failure.
Standby Mode
Standby mode is a power saving feature that can be used for non-operational transmitters. When in
standby mode, most of the transmitter's circuits are inactive, the LCD is blanked, and the transmitter
cannot be keyed. To put the transmitter into standby mode, use the following procedure.
When the transmitter is in Standby mode, the red front panel Standby indicator is lit.
To Enter Standby Mode
To Exit Standby Mode
T e s
t
S t
a
t
u s
P A S S
O K
T e s
t
S t
a
t
u s
F A I
L
O K
E n
t
e
r
S t
a n d b y
?
Y e s
N o
(1)
From the Control screen select
Standby.
(2)
At the Standby screen, select Yes.
(3)
Check that the display blanks and
the front panel Standby indicator is
lit.
E x
i
t
S t
a n d b y
?
Y e s
N o
(1)
Press the Switch.
(2)
Select Yes.
(3)
Check that the Main screen is
displayed and that the front panel
Standby indicator is unlit.
Summary of Contents for T6T
