Drilling template
(1590BB)
•
This template is approximate. Use at your own risk!
•
Make sure your printer isn't doing any scaling / is set to 100%
print size.
•
Drill DC jack and input/output jacks to your own preference.
•
I measured 20mm from the edge of the enclosure to the
center of the input jack and 37mm from the edge of the
enclosure to the center of the DC jack (on the right side, left
side when your have the enclosure upside down).
•
Measure and confirm before drilling!
•
Read the build tips section highlighted in red before soldering
pots and switches to the PCB.
Summary of Contents for Into the Unknown
Page 9: ...Schematic...
