13 MS-1000 PT2.fm
4. WEIGHT STACK LABEL INSTALLATION
Shipped with your machine is a set of labels for the weight stack numbers. Follow the
instructions printed on the label. Below is a list of weight stacks and the corresponding
label set part numbers
.
To install weight stack labels:
1. Verify weights are installed properly.
2. Wipe front surface of the weights with rubbing alcohol and allow to dry completely.
3. Remove the backing from the labels. Align the top edge of the label with the top edge of the
weights and the side of the label with the outside edge of the pin hole in the weights.
4. Verify that the label strip is straight and then remove the liner. As the liner comes off the labels,
press and rub each label into place.
5. The adhesive requires 48 hours to cure so
DO NOT
attempt to “test” the integrity of the labels
after they have been installed.
Take the time during installation to align the label with the edge of the pin hole and the
top surface of the weights to get all of the individual labels straight.
Weight Stack
170 lb.
250 lb.
Label Part No.
B2170
B2172
Liner
Individual
Align with outside
edge of pin holes
labels
