Paramount Fitness FP-285, Instruction Manual

Page: 17 / 21

OPERATING INSTRUCTIONS
CAUTION
Do not attempt to operate until you
have read and understand all General
Safety Information in this manual and
all assembly is complete and lea
‰
test has been performed.
BEFORE TURNING GAS SUPPLY ON:
for outdoor use only. Do NOT use it
inside a buildin
y\¿ garag g\¿ or any other
enclosed area.
2. Ma ‰ e sure surrounding areas are free of combustible material ¸\ gasolin g\¿ and
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections
are tight and there are no lea ‰¸ .
4. Be sure the cylinder is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
BEFORE LIGHTING:
1. Fire pit should be thoroughly ƒ¸¡gUÁg_¿Lgt”µg¿g>U¿É¸g\¿>_¿LÓ >¿ªÉ>ŠƒÚg d service person at least annually. If relighting a hot
Úµg¿¡ƒÁ\¿>ŠÑ>Ó¸ wait at least 5 minutes ¿ÑƒÁ¿Á>‰¿Ð>ŠÐg¿UŠ”¸g d.
2. Inspect the hose assembly for evidence of excessive abrasion
\¿U
uts
\
or wear. Suspected areas should be lea
‰
tested. If the
hose lea ‰¸\ it must be replaced prior to operation. Only use the replacement hose assembly ¸¡gUƒÚg_¿L y manufacturer.
WARNING
Very hot while in operation!
Do not touch Table Top or Burner
after use before placing Lid on Table Top
or touching any surfaces. Failure to comply
with these instructions may result in
serious bodily injury.
DANGER!
FOR OUTDOOR USE ONLY
CARBON MONOXIDE HAZARD
Never use this inside a house, or other
unventilated or enclosed areas. This
Ö
re pit
consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue and
not be yellow or produce thi U‰ blac ‰
smo ‰ e \ indicating an obstruction of
should be blue with straight yellow
tops. If excessive yellow
Û>g¿ƒ¸
_gÁgUÁg_\ turn off Úµg¿¡ƒÁ¿>_¿U”¸ÉŠ t
the “Troubleshooting” section near the
end of this manual.
LIGHTING:
1. Turn the control ‰ nob to “OFF” position. (Figure A)
2. Fully open LP cylinder valve. Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge
air from gas lines before proceeding.
3. *ɸ¿ƒ¿y>¸¿U”Áµ”Š¿‰”L¿>_ Áɵ¿U”ɐÁgµUŠ”U‰Ñƒ¸g to “HIGH” (Figure B) to light Ág¿Úµg¿¡ƒÁ¦¿t gg_g_\¿_g¡µg¸¸¿> d turn the
U”Áµ”Š¿‰”L¿U”É
n
ÁgµUŠ”U‰Ñƒ¸g
several times until
Ág¿Úµg¿¡ƒÁ¿Šƒy
hts (you should hear
>¿UŠƒU‰ƒy¿¸”ɐ
d each time).
4. After Úµg¿¡ƒÁ¿ŠƒyÁ¸\¿µgŠg>¸g¿U”Áµ”Š¿‰” b. If you want a lower temperature push in the control ‰ nob and turn
counterc Š”U‰Ñƒ se to the “LOW” Position (Figure C).
NOTE: If burner fails to remain lit, close all valves and wait at least 5 minutes for accumulated gas to dissipate before
attempting to light.
Figure A Figure B Figure C
OPERATING INSTRUCTIONS
17
OPERATION INSTRUCTIONS