PARAMOUNT BED 7A10473700A4, Instruction Manual

Page: 13 / 40

23
INSTALLATION
12
To avoid possible malfunctions, do not install the stretcher in the following locations.
When performing the height adjustment or inclination angle adjusment, pay attention not to hit
the wall, beam, or power outlet on the wall. The stretcher or wall may be damaged or deformed.
Make sure that the stretcher does not hit the wall, beam, during the height
adjusment or inclination angle adjusment.
Location expose to direct sunlight.
Location near heat sourches such as a stove or heater
Location which is heavily electrically charged such as near an MRI.
Location that has a high oxygen level.
Location exposed to excessive amounts of water vapor or oil vapor
Location with large amount of dust, smoke, salt, sulfur, or corrosive substances
Location with poor ventilation
Location exposed to vibriations or shocks (including during transportation)
Location where the floor is not strong enough
Location where the floor is not level.
※
The optimum ambient conditions for the stretcher are as follows.
Temperature 5
0
C to 40
0
C/ Humidity 20%RH to 90%RH / Atmospheric pressure 700hPa to 1060hPa.
Location that tend to be exposed to high temperatures, high humidity, low temperatures or dry
conditions.
CAUTION
When setting up the stretcher, make sure that there is at least 20 cm clearances from the wall. The
main frame moved back and forth during inclination angle adjusment and could hit the wall, causing
damage or deformation of the stretcher.
Secure at least 20cm clearance from the wall